Pen Type Dental Curing Light

Rolence Curing Light ELiTEDENT® Q6-NLG:

★ High, low intensity, and ramp Mode

★ 390 - 480 nm wavelength range

The ELiTEDENT Q6-NLG is a Pen-Type Curing Light, cordless, high-performance LED light source curing unit intended for polymerization of resin-based light cured dental materials by dental professionals. ELiTEDENT Q6-NLG incorporates two types of LEDs to achieve broad wavelength with the range of 390 to 480 nm output to polymerize virtually all the resins in the market and a high power mode to produce super fast curing effect. The relevant range both for camphorquinine (CPQ) and phenyl propanedione (PPD) containing product. Though the majority of light-curing dental materials are responsive in this range of wavelengths, it is suggested you should contact the filling material maker to make sure it before use.

Package includes (Accessories):

Charging Base Assembly

Hand piece Assembly

Eye shield

Wall Plug-in Power Adaptor

Activating and Deactivating the Light:

► The Curing Light will enter “sleep” mode if the unit has not been used for more than 2 minute, the panel display will turn off to conserve power. If the panel display is not illuminated, simply press on/off button to bring it out of the sleep mode.

► Activate the light by pressing the on/off button on the keypad.

► Press the on/off button again to turn off (interrupt) the light before the exposure time is over.

Adjust mode and curing time for the Light:

► Always use the settings recommended by the manufacturer of the dental material when selecting the settings.

► Please refer to the above for more information of mode selection and curing time setting.

► Make sure everyone is wearing the appropriate eye protection.

Warning signal:

► If the temperature on hand piece is over 40oC, the “H” and “L” indicator will illuminate at the same time and buzzer continuously beep 5 tones and cannot turn on curing LEDs.

► If the temperature on handpiece is over 35℃, the all indicator will illuminate at the same time and buzzer continuously beep a long tone for high temperature warning.

► If the battery voltage runs low, the “L” and “Ramp up” indicator will illuminate at the same time and buzzer beep continuously 3 tones. Please place the Curing Light back into charger for recharging.

Note:

► Follow manufacturer's directions for curing times on various materials. It is better to over cure rather than insufficient cure. Over curing should not harm the restoration.