Compact Size Piezo Scaler

Use of Tips

The ultrasonic Tip is for use in dentistry with Rolence® ELiTEDENT® Ultrasonic Scaler.

Rolence offers different kinds of ultrasonic Tips. The longer and thinner and Tip is, the better becomes its access to periodontal pockets and interproximal areas. Also, and at a constant power setting on the unit, a longer and thinner Tip delivers less clinical power. This means slower concrement removal and less pain for the patient. For gentle treatment, choose a very long and very thin Tip. Only switch to a shorter Tip if a particular treatment situation requires more power than the longer Tip can deliver.

The standard package of ELiTEDENT® PS-30 / (LED) Ultrasonic Scaler includes very few tips. To afford extra tips, please contact Rolence authorized dealer to order.

Before use of the ultrasonic Tip, please read following instruction carefully.

Introduction

Rolence Enterprise Inc. is an ISO 9001(2008), ISO 13485(2003) certified manufacturer of Ultrasonic Scalers. All the products are FDA registered and compliant with EN standards (CE Marking).

Conformance to Standards:

The Rolence® ELiTEDENT® PS-30 / (LED) Ultrasonic Scaler conforms to IEC60601-1-2:2007 and IEC60601-1-1:2006.

The device is CE marked corresponding to European Medical Device Directive (93/42/EEC)

Installation of PS Sterilizable Handpiece and Tips

This Ultrasonic Scaler is designed working with EMS® or Satelec (S) tips. Please check prints on handpiece to identify which tip spec. is required. Incorrect tip connection can cause handpiece thread damaged. Please note you can NOT connect a PS Sterilizable handpiece with LED to a Non-LED Scaler and vice versa. Use Torque Wrench to mount and drive ultrasonic tips to the appropriate PS Sterilizable handpiece gently.

Safety Precautions

Prior to installation and start-up of the Ultrasonic Scaler, carefully read the instructions provided herein!

Precautions for All Systems

1. Do not place the Ultrasonic Scaler on or next to a radiator or other heat source. Excessive heat may damage the Ultrasonic Scaler’s electronics. Place the Ultrasonic Scaler where air is free to circulate on all sides and beneath it. Do not cover vents on rear panel.

2. Always set the system's power adjustment to the lowest power setting for the application of a new or special Tip.

3. The Ultrasonic Scaler is portable, but must be handled with care when moving.

4. Equipment and dental water supply system maintenance are strongly recommended.

5. Close the water shut-off valve in the dental water supply system every night before leaving the office.

6. The use of an in-line water filter is recommended.

7. Used for the intended purpose only. The Ultrasonic Scaler must be used by other than qualified and trained personnel, in medical facilities.

8. Grounding reliability can only be achieved when the equipment is connected to an equivalent receptacle marked Hospital Only or Hospital Grade.

Precautions for Ultrasonic Prophylaxis Procedures

1. Before first use, clean, disinfect and sterilize new or repaired handpieces and Tips you wish to use with the Ultrasonic Scaler.

2. Always examine the Ultrasonic Scaler and ultrasonic tips before commencing treatment. A damaged Ultrasonic Scaler or damaged tip must not be used.

3. Ultrasonic tips that have been bent, damaged, or reshaped are susceptible to in-use breakage and should be discarded and replaced immediately.

4. Retract the lips, cheeks and tongue to prevent contact with the ultrasonic tip whenever it is placed in the patient's mouth.

#Ultrasonic Scaler #Ultrasonic Scalers #Scaling Tip #Accessories