UV curing light for Industrial Use

PLEASE NOTE!

Prior to installation and start-up of the Curing Light, carefully read the instructions provided herein!

As with all technical devices, the proper function and safe operation of this unit depend on the user’s compliance with the safety recommendations presented in these operating instructions.

1. The Curing Light is intended to be used only as specifically outlined in these Directions for Use. Any use of the Curing Light inconsistent with the Directions for Use is at the discretion and is the sole responsibility of the practitioner.

2. Keep solvents, flammable liquids, and sources of intense heat away from the Curing Light as they may damage the plastic housing of the charger, the seals, or the cover on the operating buttons.

3. To protect the light guide, after each curing procedure is completed, the handpiece should always be placed back into its holder.

4. To obtain a safety operation, we suggest that check your local AC power supply voltage before you buy and use the Curing Light product from oversea.

5. The adaptor is served to disconnect the device, not to position the equipment to make it difficult to operate the disconnection device.

6. Check unit for adequate light output before each procedure. Failure to verify output may allow inadequate curing.

7. On the applied part, light guide, the temperature may up to 43℃/110℉ at the atmosphere

temperature of 40℃/104℉.

8. In order to avoid electric shock do not introduce any objects into the unit with the exception of replacement parts handled in accordance with the Operating Instructions. Do not attempt to change the Curing LED, open or alter the unit in any way

9. Use only genuine Rolence parts when replacing defective components as directed in these Operating Instructions. The Curing Light’s warranty does not cover any damage resulting from the use of third-party replacement parts.

10. A warning that other cables and Accessories may negatively affect EMC performance.

11. A warning regarding stacking and location close to other equipment.

12. A warning that use of other accessories results in non-compliance.

The ELiTEDENT Q-6 UV Curing Light is a pen style, cordless, high-performance LED light source Curing Light intended for polymerization of resin-based light cured materials. ELiTEDENT Q-6 UV Curing Light incorporates 5W UV LED to achieve high light energy output with wavelength range of 365 +/- 10 nm to polymerize virtually resin-based composite in the market and a high power mode to produce super-fast curing effect. Though the majority of light-curing dental materials are responsive in this range of wavelengths, it is suggested you should contact the filling material maker to make sure it before use.

The ELiTEDENT Q-6 UV is a fast-curing LED Curing Light. It emits typical light energy output at about 1,000 mW/cm². 5 seconds to cure most composite in the market with 2mm thickness. It also features:

1. Multiple mode selection: boost (fast curing) and ramp up.

2. All aluminum handpiece housing for improved durability. No more plastic to stain or crack.

3. Two button easy operation.

4. Quiet operation, fan-free design.

5. Can be used both cordless and corded.

6. Low battery warning: for urgent use, just insert power cord connector into Handpiece directly.

7. Rechargeable lithium battery inside, capable of 200 x 10 sec curing cycles prior to recharging.

8. Slim handpiece for most comfortable hand holding, (weight 1g only)

9. 8 mm diameter sterilizable curing tip.

10. Curing tip rotates 360∘for curing at any position of mouth.

11. Versatile fiber optic curing tip optional.

#Curing Light #UV Spot Curing #UV Spot Curing Light #Uv Spot Curing #Uv Spot Curing Light