Industiral Use High Intensity UV Curing Light

Installation & System Interconnect

1. Make sure that the voltage indicated on the rating plate complies with local standard.

2. Selecting location: Place the UV Spot Curing Light on a flat surface. Make sure it is not exposed to the immediate vicinity of heaters or other source of heat. Protect the Uv Spot Curing Light from direct sunlight. Make sure that the system is positioned at a dry location which does not hinder the airflow circulation around the system.

3. Connect the power cord to the rear side of the UV Spot Curing Light and then plug into the grounded wall socket.

4. Remove the protective cover from the light head and channel mount.

5. Install the Curing Light head cable to the channel mount sequentially. (From Ch1, Ch2, Ch3 to Ch4.)

6. Visually inspect if the connection between the Curing Light head cable and channel mount is firm.

7. Turn on the Power by switching to (on) position.

8. No warm-up or cooling time needed. The system can be powered on and off instantly.

Unpacking and checking the contents

1 Main curing system

1 Power cord

1 User manual

1 Protective Goggle

1 4-mm Light head connected with cable (Optional)

Preface

Dear valued customer, thank you for selecting this industrial LED Uv Spot Curing Light. The Curing Light is developed and manufactured by Rolence Enterprise Inc. for polymerization of UV composite and resin. The adequate setup and operation of this system will maximize safety and user-friendly performance. Therefore, you are highly encouraged to read through, understand and follow the instructions in this user manual and other related material before setting up and operating this system. Please contact with our distributors or write directly to us if you need further support.

Inappropriate use may damage the UV Spot Curing Light be harmful to human body. Please read the relevant safety instruction in this user manual carefully. This will also help you use the Curing Light properly and easily.

“SET UP” mode and “Operation” mode

(1) Turn on the power switch on the rear side.

(2) The LED light above the CH1 to Ch4 will be ON if it is connected.

(3) The default channel is CH1 which is RED and other channel is Green

(4) There are “SET UP” mode and “Operation” mode.

(5) While the unit is at “SET UP” mode, the “READY” LED is red, and user can set the timer and light intensity for each channel

(6). While the unit is at “Operation” mode, the “READY” LED is green and it is ready to operate.