High Intensity Industrial Use UV Spot Curing Light

Preface

Dear valued customer, thank you for selecting this industrial LED UV Spot Curing Light. The Curing Light is developed and manufactured by Rolence Enterprise Inc. for polymerization of UV composite and resin. The adequate setup and operation of this system will maximize safety and user-friendly performance. Therefore, you are highly encouraged to read through, understand and follow the instructions in this user manual and other related material before setting up and operating this system. Please contact with our distributors or write directly to us if you need further support.

Inappropriate use may damage the Uv Spot Curing Light be harmful to human body. Please read the relevant safety instruction in this user manual carefully. This will also help you use the Curing Light properly and easily

Unpacking and checking the contents

1 Main curing system

1 Power cord

1 User manual

1 Protective Goggle

1 4-mm Light head connected with cable (Optional)

Installation & System Interconnect

1. Make sure that the voltage indicated on the rating plate complies with local standard.

2. Selecting location: Place the UV Spot Curing Light on a flat surface. Make sure it is not exposed to the immediate vicinity of heaters or other source of heat. Protect the Uv Spot Curing Light from direct sunlight. Make sure that the system is positioned at a dry location which does not hinder the airflow circulation around the system.

3. Connect the power cord to the rear side of the UV Spot Curing Light and then plug into the grounded wall socket.

4. Remove the protective cover from the light head and channel mount.

5. Install the Curing Light head cable to the channel mount sequentially. (From Ch1, Ch2, Ch3 to Ch4.)

6. Visually inspect if the connection between the Curing Light head cable and channel mount is firm.

7. Turn on the Power by switching to (on) position.

8. No warm-up or cooling time needed. The system can be powered on and off instantly.

“SET UP” mode and “Operation” mode

(1) Turn on the power switch on the rear side.

(2) The LED light above the CH1 to Ch4 will be ON if it is connected.

(3) The default channel is CH1 which is RED and other channel is Green

(4) There are “SET UP” mode and “Operation” mode.

(5) While the unit is at “SET UP” mode, the “READY” LED is red, and user can set the timer and light intensity for each channel

(6). While the unit is at “Operation” mode, the “READY” LED is green and it is ready to operate.

Timer irradiation

Control the irradiation on-off by the EMISSION switch of the controller.

Note: The displayed values apply to the selected channel.

1) Starting irradiation

I. Follow chapter 4.2 to set up irradiation time for each channel.

Note: If you want to disable an active channel, please set the timer to 0 SEC.

II. Press the EMISSION switch

Note: Irradiation will start on all the active channels with green indicator while the EMISSION switch glows red during irradiation. The display will count irradiation time backward. Irradiation stops after irradiation is finished on all channels.

2) Stopping irradiation

While irradiation is in progress, press the EMISSION switch again to stop. The irradiation will be stopped on all channels accordingly.